![]() ![]() At some point after the update, the shipping label designs will change slightly to reflect new standards.While functionality should be identical to previous versions of Endicia for Mac, there have been many changes under the hood, please let us know if you experience any issues. Support for upcoming improvements to your Endicia account.See the important notice below before updating to version 3.0 if you print individual stamps using Endicia for Mac.If nothing prints, contact DYMO LabelWriter Printer Technical Support.Ĭopyright © 2016 Endicia.The DYMO Printer Properties dialog box appears. Right-click the LabelWriter printer icon, and select Properties from the shortcut menu. If the printer is not available, see Steps 1 and 2 in the preceding set of steps. A grayed out or dimmed printer icon would indicate that the printer is installed but is not available (such as not getting power or is disconnected). Verify that the printer icon is not grayed out or dimmed. In Windows 7, select Start and select Devices and Printers.) (In Windows 7, this is in the Control Panel under Hardware and Sound Devices and Printers. The Printers and Faxes Control Panel appears. Display the Printers and Faxes Control Panel: From the Start menu, select Settings > Printers and Faxes.Note: The following procedures and terms vary according to the version of Microsoft Windows that you are using.To reduce the chances of wasting "live" postage and supplies, it is highly recommended that you print a test label. The driver was automatically installed when you installed DYMO Label Software, but the software may have been changed or deleted by mistake. MORE This process takes test page data from DYMO Label Software and directs it to the LabelWriter printer. Print a test page from the LabelWriter printer driver.Make sure the leading edge of the first label is inserted correctly in the label slot. the first label may not be loaded in the label slot correctly. Verify that both sides of the spool are flush against the label roll and that the labels are fed into the label slot with the left edge flush against the left side when viewed from the front. Verify the label roll and load or reload the labels as shown in the LabelWriter Quick Start Card. the labels are not loaded correctly or the label spool is empty. ![]() Make sure both sides of the spool are flush against the label roll and the labels are fed into the label slot with the left edge flush against the left side when viewed from the front. Remove the labels from the spool and reload them as shown in the LabelWriter Quick Start Card. the labels are not loaded correctly on the label spool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |